ION Slides 2 PC Guia Del Usuario página 5

USING THE INCLUDED HOLDERS
SLIDE HOLDER
1. Open the film holder by lifting the tab on the bottom.
2. Insert the slide(s) into the slide slot(s) or lay the negative over the negative slot.
3. Close the film holder. Be sure the latch and sides of the holder are securely in place.
ROLL FILM HOLDER
1. Lay the film holder flat.
2. Insert one end of the roll of film in the slot on the right-hand side of the holder.
3. Gently push/pull the roll of film through the holder to move from picture to picture.
Tip: To avoid laying a negative in the wrong direction (which will produce a mirror image), be sure you
can correctly read the serial numbers at the top of the negative when placing it in the holder.
RAPID SLIDE FEEDER
1. With the lever all the way to the right, stack your slides in the rapid slide feeder.
2. Place the rapid slide feeder into the FILM HOLDER SLOT.
3. Push the lever towards the left, then pull the lever back to the right again to load a slide from the feeder
into SLIDES 2 PC. Repeat this step for subsequent slides (which will push the used slides out the
other side).
All manuals and user guides at all-guides.com
5