WESTEK LPL595S Manual Del Propietário

LPL595S Owner's Manual
Location of Controls
1. Tap ON/OFF Lens
2. Pull Cord
3. Battery Compartment*
*Underneath unit
Installation
Screw (included)
1. Drill two pilot holes in the location where you want to mount the Utility light. You can use the battery
compartment as a guide to see where the screws have to go.
2. Screw battery compartment in pre-drilled holes using screws (included). Prongs should face down as
shown.
3. Attach the Utility light to battery compartment by lining up prongs with the openings on the light.
Once lined up, turn light clockwise to lock in place.
Operating Directions
ON/OFF Operation
1. Push light head or pull cord to turn ON.
2. Push light head or pull cord again to turn the light OFF.
CAUTION: When using the pull cord to operate the light, make sure not to pull the cord too hard to rip
unit off mounting surface.
Inserting/Replacing the Batteries
If the LEDs appear to be dim this is an indication that your batteries need to be replaced.
To Replace Batteries Once Utility Light is Mounted:
1. Utility Light body will release from battery compartment cover/mounting bracket easily. Turn light
counter-clockwise in oder to unlock unit from battery compartment.
2. Remove old batteries (if replacing batteries).
3. Replace with three (3) new AA batteries.
4. Make sure to follow battery polarity guide when installing new batteries.
5. Attach the Utility light to battery compartment by lining up prongs with the openings on the light.
Once lined up, turn light clockwise to lock in place.
Battery Precautions:
1. Use only the size and type of batteries specified.
2. Always purchase the correct size and grade of battery most suitable for the intended use.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
Reversed batteries may cause damage to the device.
4. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries.
5. Replace all batteries of a set at the same time. Do not mix old and new batteries.
6. Clean the battery contacts and also those of the device prior to battery installation.
7. Do not dispose of batteries in fire.
8. Remove batteries if consumed or if product is to be left unused for an extended period of time.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING: Modifications to this product not approved by the party responsible for compliance could void the user's authority to operate the product.
Limited Warranty
Under normal use and conditions, AmerTac provides to the original purchaser of this product a one year limited express warranty
that is set forth in the Limited Warranty stated in full at www.amertac.com/warranties. The Limited Warranty is in lieu of all other
express or implied warranties or liabilities subject to the exceptions explained fully in the Limited Warranty on the website.
BATTERY OPERATED LED
UTILITY LIGHT WITH PULL STRING
250 Boulder Dr.
Breinigsville, PA 18031
610-336-1330
www.amertac.com
Made in China / Fabriqué en
Chine / Fabricado en China
© 2018 AmerTac™
I18-0045-A