Assembly/Operation - Scotts BLR20085S Manual Del Operario

UNPACKING
This product requires assembly.
Carefully remove the product and any accessories from the
box. Make sure that all items listed in the packing list are
included.
Inspect the product carefully to make sure no breakage or
damage occurred during shipping. Do not discard the packing
material until you have carefully inspected and satisfactorily
operated the product .
PACKING LIST

Blower

Blower Tube

Owner's Manual
ASSEMBLY
1. Connect the larger end of the blower tube to the
blower housing.
2. Make sure the blower tube release clip snaps into the
hole in the blower tube.
3. To remove, press in on the clip then remove in the
reverse direction.
WARNING: Make sure the blower tube is fixed in position
before operating the blower.
ON/OFF SWITCH/SPEED CONTROL
For extra control, model BLR20085S is fitted with a two speed
switch located on the handle of the power head.
The switch has three positions: "O", "1" and "2".
Position "O" is off. To use in low speed, move the switch to
the center position "1". To change to high speed, move the
switch to position "2".
To turn the tool ON, slide the switch to position "1" or position
"2", depending on the desired speed.
To turn the tool "OFF", slide the switch to the "O" position.
Hold the blower tube approximately 7
inches above the ground, switch your
product on and using a sweeping motion
from side to side, advance slowly. Keep
the accumulated debris/leaves in front of
you.
CAUTION: The blower can throw debris,
possibly causing serious personal injury
to the operator or bystanders.
Use your product only in daylight or good artificial light.
The blower is intended for residential use only. Use the blower
outdoors to move debris as needed.
WARNING: Always wear safety glasses to prevent debris from
being blown into eyes and face, which can cause serious injury.
Do not blow hard objects such as nails, bolts, or rocks.
Do not operate the blower near bystanders or pets.
Use extra care when cleaning debris from stairs or the tight
areas.
When not in use, store the blower and extension cord indoors, in
a cool dry place.

ASSEMBLY/OPERATION

4
Model BLR20085S
"O"= OFF
"1"= LOW
"2"= HIGH