Power Connection - Boston SoundWare Manual Del Propietário

The level of bass output from the subwoofer will vary at different positions in a room. When placed near walls, its loudness is
emphasized. Corner placement provides the most bass output. Placement completely away from walls may produce too little
bass. Regardless of the natural bass level within the room you will always have the ability to adjust the level of the subwoofer
with the built in volume control. If you move the subwoofer you may need to adjust the control settings to get the best
performance.
Connections
Important: Before connecting the SoundWare Sub, be sure the power switch on the amplifier panel is set to "Off" and all the
other components in the system are turned off. Also be sure to turn off the Sub and all other system components any time
you change the system connections.

Power Connection

Connect the supplied power cord to the power input on the
SoundWare Sub amplifier panel. Plug the cord directly into
a wall outlet or some other dedicated power outlet. Do
not use an extension cord unless it is a very heavy
duty cord intended for high power applications.
Do not use a multi-outlet power strip or surge
protector unless it is capable of handling high
power levels. If a heavy duty power strip or
surge protector is used, do not connect
any other components to it.
Never connect the SoundWare Sub power cord to an auxiliary power outlet on another component. These power outlets do
not provide adequate amounts of power, or the proper isolation required.
Warning: Connecting the SoundWare Sub to an inappropriate power source increases the risk of fire and damage to the
system components.
Position subwoofer
in corner for maximum
bass output
SoundWare Subwoofer
Important: Do not place the subwoofer
where there is a chance of contact between
the amplifier panel and adjacent drapery or
furniture.
Connect the supplied power cord.
Connect the supplied power cord.
Plug it into an appropriate power outlet
Plug it into an appropriate power outlet
Set the Power switch to o and
Set the Power switch to off and turn
turn o all other system components
off all other system components
before making any connections
before making any connections
5