Zenith Heath 6168 Manual Del Usuario página 2

Important considerations: The sensor must be mounted to the door jamb. The
magnet should be attached to the door. Sensor is for indoor use only.
WARNING: To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
Use Optional
Spacer if Needed
Alignment Arrows
1/2" Maximum
Installation
2. Install alkaline type A23 12 volt push button
battery (included). Remove back of case by
pushing in tab on bottom with a small screw-
driver. See diagram inside sensor for correct
battery orientation.
3. Select mounting location. The maximum gap
between sensor and magnet is 1/2" (13 mm).
The arrows located on the face of each com-
ponent must be aligned and facing toward each
other. The magnet must be beside the sensor.
Note: If the magnet is recessed, use spacer to
ensure proper alignment.
4. Test range. Before mounting, hold sensor and
magnet in selected location and verify opera-
tion. While holding the sensor still, move the
magnet away from the sensor to simulate door
being opened. Verify red LED on sensor flashes
momentarily and chime sounds. Note: If sensor
does not operate correctly, see Troubleshooting
Guide.
-2- 595-5724-04