Tabla de contenido
Publicidad
14
M100
M100 Controls
(2)
(3)
(4) (5)
(1)
(11)
(12)
(10)
(6)
(7) (8)
(9)
(13)
Step 2: Controls
(EN)
(1)
(7)
INPUT knob adjusts the
PARAMETER knob adjusts
input signal level.
the fi rst parameter of
the currently-selected
(2)
INPUT LEDs light green
eff ect. The center position
when signal is entering
is the default setting
one or both of the inputs,
for each preset. When
and lights red when the
changes are made for a
incoming signal clips the
preset, the settings will be
inputs. If the LEDs light
temporarily saved until the
red, lower the input knob.
unit is powered off . See the
'FX Parameters' chapter
(3)
OUTPUT knob adjusts the
for details.
output level.
(8)
TAP/SELECT button
(4)
MIX knob adjusts the
performs 2 functions:
balance of the dry/
unprocessed signal (fully
• TAP Tempo –
counterclockwise) and the
processed eff ect signal
(fully clockwise).
(5)
BYPASS button enables
and disables the eff ect
signal. The adjacent LED
will light when the unit is
in bypass mode, leaving
the sound unaff ected.
(6)
EFFECTS knob selects one
• Parameter SELECT – for
of the 16 eff ect presets.
See the 'FX Descriptions'
chapter for details.
Quick Start Guide
(9)
POWER LED lights when
the unit is powered on.
(10)
POWER INPUT accepts the
included power supply.
(11)
FOOTSW(itch) jack
accepts a ¼ " TS cable for
connection of a footswitch
to remotely bypass the
eff ect signal.
(12)
OUTPUT jacks send the
processed signal via
¼ " TRS connectors.
(13)
INPUT jacks accept
¼ " TS or TRS cables from
for eff ects that
the source that will be
have a time - based
processed. Use the Input 1
parameter, tapping
(left) for mono signals.
this button in rhythm
with the music will
set delay time or
modulation rate.
The LED will fl ash
to indicate the
current tempo.
eff ects that have a
parameter toggle,
pressing this button
once will change the
parameter value,
indicated by a lit LED.
15
Publicidad
Tabla de contenido
