Connection And Operation - in-akustik Exzellenz HDMI Cross Switch Manual De Instrucciones

OPERATION MANUAL
Note:
Output-A supports an unmodified SPDIF (coaxial) digital audio output. Users can use it to connect
•
to a Home Theater system which supports a coaxial digital audio input.
The output of the SPDIF (Coaxial) digital audio format is based on the HDMI Output-A. If the sink
•
devices (HDTV or Projector), which connected to Output A and Output B, can only support stereo
audio, the coaxial digital audio may also send out PCM stereo audio.
For audio output format adjustment: (Please refer to the source device manual.)
•
Check the supported audio format of the feature film. (Stereo, DTS
•
5.1...etc)
Set the audio output format of source device. Ex. uncompressed PCM or Bit Stream (Dolby
•
5.1, DTS
Select the output of audio format and language from the main feature menu.
•
For HD quality audio (Dolby
•
high bandwidth for audio transmission, please use HDMI connection for the HD audio transmission.
If the output audio format is not supported by the sink device (HDTV, Home Theater receiver,
•
Sound Bar Speaker), you may hear noise form the speakers or you will not hear any sound from the
speakers.
If you want to use a Home Theater System or other speaker system for audio output, it is
•
recommended to mute the audio speaker of the HDTV.
Exzellenz HDMI Cross Switch is designed with Highest Common Factor detection mode. When use it
•
in the splitter function, the sink device with lower standard will be set as the primary device.
It is recommended all connected sink devices (HDTV, Projector, Home Theater Receiver...etc.) and
•
sources device (Blue-ray Player, PS3...etc.) support same highest resolution, color deep and audio
format.
Batteries must be placed in empty state at the collection points.
•
In addition to precautions take care against short circuits (e.g. by isolating the pole with tape).

Connection and operation

Connection
Step 1: Connect the DC 5V power adaptor to the Exzellenz HDMI Cross Switch.
Step 2: Connect the HDMI cables from the HD sources (PS3, DVD player, Blue Ray DVD Player...etc) to the
input ports of the Exzellenz HDMI Cross Switch.
Step 3: Connect the HDMI cables from your HD display (HDTV or projector) to the output port (Port A or
Port B) of the Exzellenz HDMI Cross Switch.
Output Port A support additional SPDIF digital audio output. If your Home Theater (or Sound
System) doesn't support HDMI input, you can use a coaxial audio cable to connect the digital audio
to your Home Theater (or Sound System).
Step 4: After you finish the connection, the Active-A (or Active-B) indication LED (red), and input indication
LED (green) will be lighted on.
10
Operation
A
Matrix Mode:
Splitter Mode:
A
A
Splitter Mode:
®
5.1 ...etc.)
®
TrueHD, DTS-HD Master Audio
Select different signal
B C D
Share same signal
B C D
B C D
® ®
5.1, and Dolby Digital
TM
), or other audio formats that need
A C
C C
C
®
Digital
C