Black and Decker Price Pfister Brookwood 34 Serie Manual Del Usuario página 3

7
7E
7D
7F
7 SECURING THREE HOLE FAUCET TO DECK
From underneath sink, secure the Hose Guide (7A) by screwing the Plastic Locknut
(7B). Secure Deck Plate (7C) by screwing Wing Nut (7D) to Mounting Post (7E). Hand
tighten. Remove any excess putty from around the outside edge of Deck Plate (7C).
Secure faucet by placing the Metal Washer (7F) and the Long Nut (
Mounting Post (7H). Make sure that the bumps on the Metal Washer (7F) are facing up.
Tighten until the faucet is firmly connected to the sink. Do not over tighten!
STOP
8
8A
8B
8 FOUR HOLE FAUCET INSTALLATION
Following manufacturer's recommendations on use, apply plumber's putty into putty
groove in Bottom Plate (8A). Insert the faucet Supply Tubes (8B) through the center
hole of the sink. Insert faucet Shanks (8C) through the end holes of the sink.
ENGLISH
7C
7H
7A
7B
7G
7
/ Hex.) (7G) onto
16
Go To Step 11
8C
9
9C
9A
9D
9E
9 SECURING FOUR HOLE FAUCET TO DECK
From underneath sink, hand tighten Wing Nuts (9A) to Mounting Posts (9C). Remove
any excess putty from around the outside edge of Deck Plate (9B). From underneath
sink, secure the faucet by placing the Metal Washer (9D) and the Long Nut ( 7 / 16 Hex.)
(9E) onto the Mounting Post (9F). Make sure that the bumps on the Metal Washer (9D) are
facing up. Tighten using a flat head screwdriver or an adjustable wrench until the faucet is
firmly connected to the sink. Do not over tighten!
10
10 HOSE GUIDE INSTALLATION
Insert Hose Guide Shank (10A) through Flange Gasket (10B) and into the sink hole.
From underneath sink, secure Hose Guide (10A) by screwing Plastic Locknuts (10C).
Hand tighten.
Caution: do not over tighten!
3
9B
9F
9C
9A
10A
10B
10C