Philips HS8023 Manual De Instrucciones página 14

EngliSH
16
Question
Why does
little shaving
conditioner
come out of
the holes even
though there
is enough
conditioner in
the cartridge?
Why
doesn't any
shaving
conditioner
come out
of the holes
when I press
the shaving
conditioner
button?
Answer
You may not have reassembled the shaving unit
properly after extra-thorough cleaning. When you
reassemble the shaving unit, make sure you turn each
guard anticlockwise until it locks into position.
One of the conditioner holes may be blocked. Rinse
or soak the shaving unit. If this does not work, pump
shaving conditioner into the shaving conditioner
cartridge until conditioner starts to come out of the
blocked hole. If this does not work either, try the
following method: 1) Switch off the shaver 2) Pull the
shaving unit off the shaver 3) Put your finger on the
hole that is not blocked 4) Switch on the shaver 5)
Press the shaving conditioner button several seconds
until conditioner starts to come out of the blocked
hole again.
You may not have put the shaving heads back into
their original holders. One of the shaving heads does
not have a shaving conditioner hole in its centre and
needs to be placed in a specific holder. Make sure
you put the shaving head without conditioner hole in
the correct holder.This is the holder that is closest to
the on/off button when the shaving unit is assembled
on the shaver.
The shaving cartridge is almost empty. Refill the
shaving conditioner cartridge (see chapter 'Getting
started').