JENN-AIR JGC1430 Manual De Instalación página 12

Holding Unit Down To Countertop
I M P O R T A N T
To hold the cooktop to the counter top, two hold down
brackets have been provided. Utilize the hold-down
brackets, one on the left and one on the right side of unit
to secure the unit to the counter top.
Position the cooktop in the cutout opening.
Open cabinet doors and locate screw holes at right and
left side of unit bottom. Holes are half way between front
and rear of unit and approximately 1 1/4" from each side.
Thread the long hold-down screws into the hold-down
brackets.
Tighten hold-down screws to snug the unit top down
against the counter top. See figures 18 and 19. Do not
overtighten.
FIGURE 18
HOLD-DOWN
BRACKET
BURNER BOX
HOLD-DOWN
SCREW
How To Remove Cooktop For
Servicing
Follow this procedure to remove the cooktop for servicing:
1. Shut off gas supply to the cooktop.
2. Disconnect electrical supply to appliance, if
equipped.
3. Disconnect gas supply tubing to appliance.
4. Remove hold down brackets. (See figure 19).
5. Reverse the procedure to reinstall. If gas line has
been disconnected, check for gas leaks after
reconnection.
NOTE: A qualified servicer should disconnect and
reconnect the gas supply.
The servicer MUST follow installation instructions
provided with the gas appliance connector and the
warning label attached to the connector.
Service-Parts Information
When your cooktop requires service or replacement parts,
contact your dealer or authorized service agency. Please
give the complete model and serial numbers of the unit
located on the cooktop model number plate.
12
COUNTERTOP
HOLD-DOWN
BRACKET
FIGURE 19