Troubleshooting - Black+Decker BDPH950 Manual De Instrucciones

18 • ENGLISH
Warning! Never hold the spray gun MOTOR part under
water or immerse it into liquids. Clean the housing only
with a moistened cloth.
5. Clean the outside of the spray gun and container
with a cloth soaked in solvent or water.
MAINTENANCE AND STORAGE
Use only mild soap and damp cloth to clean the power
unit. Never let any liquid get inside the power unit; never
immerse any part of the power unit into a liquid.
Important! To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment (other
than those listed in this manual) should be performed
by authorized service centers or other qualified service
organizations, always using identical replacement parts.
The sprayer contains a washable/reuseable filter (Fig. V).
Check the filter before and after each use. If dirty, wash
with warm water and allow to air dry before re-installing or
replace if necessary.
f To check the filter, remove the filter cover by
loosening the two screws in the cover and pulling
the cover off the sprayer. Remove the filter as shown
in figure V and inspect. Replace filter and filter cover.
PROBLEM
No coating material emerges
from the nozzle
Coating material drips from the nozzle
Atomization too coarse
SERVICE INFORMATION
BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER
Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service.
For more information about our authorized service centers and if you need technical advice, repair, or genuine factory
replacement parts, contact the BLACK+DECKER location nearest you, or visit us at www.BlackandDecker-la.com
Make sure unit is clean and dry before storing. Store unit
indoors in a dry location. To prevent damage, wrap the
electrical cord so that it is not crimped during storage.
PROTECTING THE ENVIRONMENT

TROUBLESHOOTING

POSSIBLE CAUSE
Nozzle clogged
Feed tube clogged
Material volume setting turned too far to
the dowside(-)
Feed tube loose
No pressure build-up in container
Viscosity of coating material too high
Nozzle loose
Nozzle worn
Coating material assembly at air cap,
nozzle or needle
Viscosity of coating material too high
Material volume too large
Nozzle contaminated
Air filter heavily soiled
Too little pressure build-up in container
Snugly tighten screws. Never operate the sprayer
without the filter in place. Debris could be sucked in
and interfere with the function of the sprayer.
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your
BLACK+DECKER product needs replacement, or
if it is of no further use to you, do not dispose of it
with household waste. Make this product available
for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
POSSIBLE SOLUTION
Clean
Clean
Turn to the upside (+)
Insert
Tighten container
Thin the paint
Tighten nozzle
Change nozzle
Clean
Thin
Turn material volume adjusting screw to
the downside (-)
Clean
Change
Tighten container