Black+Decker BC12 Manual De Instrucciones página 28

28 • ENGLISH
f When using this unit close to the vehicle's battery and
engine, stand the unit on a flat, stable surface, and
be sure to keep all clamps, cords, clothing and body
parts away from moving vehicle parts.
f Never allow Red and Black clamps to touch each
other or another common metal conductor — this
could cause damage to the unit and/or create a
sparking/explosion hazard.
a. For negative-grounded systems, connect
the Positive (Red) clamp to the Positive
ungrounded battery post and the Negative (Black)
clamp to the vehicle chassis or engine block
away from the battery. Do not connect the clamp
to the carburetor, fuel lines or sheet-metal body
parts. Connect to a heavy gauge metal part of the
frame or engine block.
b. For positive-grounded systems, connect
the Negative (Black) clamp to the Negative
ungrounded battery post and the Positive
(Red) clamp to the vehicle chassis or engine block
away from the battery. Do not connect the clamp
to the carburetor, fuel lines or sheet-metal body
parts. Connect to a heavy gauge metal part
of the frame or engine block.
f If the connections to the battery's Positive and
Negative terminals are incorrect, the reverse polarity
indicator will light (red) and the unit will sound a beep.
Disconnect clamps and reconnect to battery with
correct polarity.
f Always disconnect the Negative (Black) jumper cable
first, followed by the Positive (Red) jumper cable,
except for positive grounded systems.
f Do not expose battery to fire or intense heat since
it may explode. Before disposing of the battery,
protect exposed terminals with heavy-duty electrical
tape to prevent shorting (shorting can result in injury
or fire).
f Place this unit as far away from the battery as DC
cables permit.
f Never allow battery acid to come in contact with this
unit.
f Do not operate this unit in a closed area or restrict
ventilation in any way.
Warning! First Aid:
Skin: If battery acid comes in contact with skin, rinse
immediately with water, then wash thoroughly with soap
and water. If redness, pain, or irritation occurs, seek
immediate medical attention.
Eyes: If battery acid comes in contact with eyes, flush
eyes immediately, for a minimum of 15 minutes and seek
immediate medical attention.
f Important: This unit is delivered in a partially charged
state. Fully charge unit with a household extension
chord (not supplied) for a full 48 hours before using for
the first time. You cannot overcharge the unit using
the AC charging method.
f All ON/OFF switches should be in the OFF position
when the unit is charging or not in use. Make sure all
switches are in the OFF position before connection to
a power source or load.
f Never insert anything other than the supplied
recommended appliance power/recharging cords into
the 12V DC power outlet on this unit.
f Do not use any accessory that is not recommended or
provided by the manufacturer.
f Do not use this unit to operate appliances that
need more than 5 amps to operate from the 12V DC
accessory outlet.
f This system is designed to be used only on vehicles
with a 12V DC battery system. Do not connect to a 6V
or 24V battery system.
f This system is not designed to be used as a
replacement for a vehicular battery. Do not attempt
to operate a vehicle that does not have a battery
installed.
f Excessive engine cranking can damage a vehicle's
starter motor. If the engine fails to start after the
recommended number of attempts, discontinue jump-
start procedures and look for other problems that may
need to be corrected.
f Do not use this jump-starter on a watercraft. It is not
qualified for marine applications.
f Although this unit contains a non-spillable battery,
it is recommended that unit be kept upright during
storage, use and recharging. To avoid possible
damage that may shorten the unit's working life,
protect it from direct sunlight, direct heat and/or
moisture.
f Read and understand this instruction manual before
using this unit.
ADDITIONAL SAFETY INSTRUCTIONS FOR
BATTERIES AND CHARGERS
BATTERIES
f Never attempt to open for any reason.
f Do not expose the battery to water.
f Do not expose the battery to heat.
f Do not store in locations where the temperature may
exceed 40°C.
f Charge only at ambient temperatures between 10°C
and 40°C.
f Charge only using the charger provided with the
appliance/tool.
f When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
f Do not damage/deform the battery pack either by
puncture or impact, as this may create a risk of injury
and fire.