Safe Working - GEHEIT ABAC SG 90 E Instrucciones Para El Servicio

4.2

Safe Working

Comply with the requirements of accident prevention regulation „Pro-
l
cessing of Coating Materials" (VBG 23).
All persons using the ABAC Blower Unit must have read and under-
l
stood this Operating Manual, particu larly the section entitled „Notes
on Safety".
The ABAC SG 90 E Blower Unit is not of flame-proof design.
l
It must not be used in works locations subject to the provisions of ex-
l
plosion prevention regulations, or on premises and in areas where the-
re is a risk of fire.
Use only paints and solvents with a flash point of 21 °c or higher wi-
l
thout additional heating (see details on paint tin).
When working in confined spaces, these must be properly ventilated
l
using effective technical ventilation systems.
The SG 90 E Blower Unit must be placed at a distance from the spray-
l
ing area (minimum distance 5 m) due to a fire and explosion hazard
from ignitable spray mist.
Take care to ensure that there are no ignition sources in the vicinity,
l
such as naked flames, sparks, glowing wires, hot surfaces, lighted ci-
garettes, etc. The distance between spray jet exit and a possible sour-
ce of ignition (even the device itself) must be at least 5 m (fire and
explosion hazard from ignitable spray mist).
The sprayed paint emerges from the nozzle at high pressure. Never
l
direct the spray jet at people or animals. If the skin is injured by paint,
lacquer or solvent there is a risk of infection. Seek medical treatment
immediately and tell the doctor which paint, lacquer or solvent was
used.
Poisonous fumes may be given off during spraying (see paint tin for
l
details). Use a breathing mask as directed by paint manufacturers' ins-
tructions. Keep children and other people away from the working area.
Keep the ABAC SG 90 E Blower Unit in a safe place that is inac-
l
cessible to children and unauthorized personnel. Make sure that no
unauthorized personnel (particularly children) can put the ABAC
Compressor into operation.
23