Parts List; Tools Required; Installation Instruction - habitat et jardin Jesus 1293 Serie Manual Del Usuario

INSTRUCTIONS. USE CAUTION WHEN USING THIS UNIT.

1. PARTS LIST

1 x BACKBOARD
1 x METAL (BASKETBALL) RING
1 x NYLON NET
6 x SCREWS (DYNABOLTS ARE RECOMMENDED FOR THIS APPLICATION,
DYNABOLTS NOT INCLUDED).

2. TOOLS REQUIRED

DRILL
10MM MASONRY DRILL BIT
LADDER
M12 SPANNER
6 x 10MM RAM PLUGS OR PLASTIC DOWELS

INSTALLATION INSTRUCTION

 UNPACK ALL COMPONENTS AND CHECK FOR COMPLETENESS.
 BEFORE ASSEMBLING TO WALL CHECK WITH REGISTERED BUILDER OR PROFESSIONAL
ENGINEERS THAT THE WALL IS A SUITABLE LOAD BEARING WALL.
 PLACE THE BOARD IN THE REQUIRED POSITION AND MARK THE 6 HOLES THROUGH THE BOARD.
(ENSURE NONE OF THE HOLE ARE INTO THE MORTAR)
 THE HEIGHT OF THE RING SHOULD BE 3.05M (10 FEET) FROM THE GROUND.
 DRILL THE SIX HOLES, (55MM DEEP) WITH MASONRY DRILL.
 KNOCK THE RAMPLUGS OR PLASTIC DOWELS INTO ALL HOLES.
FIT THE BACKBOARD TO THE WALL USING 2 TOP SCREWS FIRST.

 FIT THE REMAINING 4 SCREWS THROUGH THE RING AND BACKBOARD.
NOTE: THE HOOKS ON THE RING MUST FACE DOWN.
 HANG THE NET. THE RED SECTION OF NET TO THE TOP.
 IF YOU ARE UNSURE OF ANY OF THE ASSEMBLY SEEK PROFESSIONAL ADVICE.