Additional Parts Available To Purchase; Installation - ETI SHOREBREAKER COL-11-802-MV-O-W Guía De Uso Y Cuidado

Pre-installation (continued)

ADDITIONAL PARTS AVAILABLE TO PURCHASE

nOte: Separate parts not shown to actual size. Contact ETi for
more information and to purchase.
Part Description quantity Model #
90600508
F Decorative Guard 1
90600507
90600504
G Decorative Guard 1
90600503

installation

WarninG: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
1
Removing the lens cover from the
fixture housing
□ Remove the lens cover (A) by loosening the 4 screws
attaching it to the fixture housing (C). Set the screws
aside until ready to reassemble the fixture.
□ Remove the fixture screw that attaches the light
board (B) to the fixture housing (C) and set aside until
ready to reassemble the fixture.
□ Detach the light board (B) from the fixture housing (C).
B
A
Lens
Screws
Fixture
Screw
Color
White
Black
White
Black
2
Feeding the wires through the fixture
housing
□ Feed the wires from the light board (B) through the hex
nut (AA) and then through the fixture housing (C).
□ Insert the threaded nipple (DD) through the the center hole
of the mounting bracket (EE).
□ Thread the wires through the threaded nipple (DD) and the
mounting bracket (EE).
DD
C
AA
C
4
installation (continued)
3
Making the electrical connections
□ Connect the hot and neutral (black and white) wires from the light
F
board (B) and fixture housing (C) to the same color wires from the
electrical box.
□ Connect the green wire from the light board (B) and fixture
housing (C) to the ground wire from the electrical box.
□ Cover the wire connections using the wire connectors (BB).
□ Wrap the wire connectors (BB) with electrical tape for a more
G
secure connection.
□ Position the wires back inside the electrical box.
B
AA
5
Mounting the fixture housing
□ Position the fixture housing (C) onto the
threaded nipple (DD).
□ Tighten the hex nut (AA) onto the threaded
nipple (DD) until the fixture housing (C) is
securely attached to the mounting surface.
B
EE
AA
4
Securing the mounting bracket
□ Place the mounting bracket (EE) over the
electrical box.
□ Use the electrical box screws (CC) to secure the
mounting bracket (EE) to the electrical box.
C DD EE
BB
6
Securing the light board to the fixture
housing
□ Place the light board (B) onto the fixture housing (C), aligning the
screw holes with those in the fixture housing (C).
□ Use the fixture screw that was previously set aside to secure the
light board (B) to the fixture housing (C).
C
B
Fixture
Screw
DD
5
Please contact 1-855-384-7754 for further assistance.
B C EE
AA CC
C
WWW.ETiSSL.COM