Start Up; Operation - Kärcher KM 75/40 W Bp Manual Del Usuario

Ocultar thumbs Ver también para KM 75/40 W Bp:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 52
Charging process - KM 75/40 W Bp Pack
Caution: Batteries may only be charged at
room temperature!
Note: Normally, the machine is equipped
with maintenance-free batteries.
 Open the device hood.
 Insert the plug of the charger into the
socket.
Note: The charger has electronic controls
and automatically switches off the charging
process. All functions of the machine are
automatically interrupted during the charg-
ing process.
The battery display shows the progress of
the charging process when the plug is in-
serted:
Batteries are being
charged
Batteries are charged
Fault display:
Charger or motor control
glows red
malfunction
Charging process - KM 75/40 W Bp
 Open the device hood.
 Insert the charging cable of the charger
in the charger box of the sweeper
 Plug in mains connector and switch on
charger.
After charging
 KM 75/40 W Bp Pack
 Disconnect the mains plug.
 Wrap the mains cord around the cable
holder of the charger.
 Close cover.
 KM 75/40 W Bp
 Switch off the charger and remove the
plug from the socket.
 Hang out the charging cable out of the
machine.
 Close cover.
Remove the battery
 Open the device hood.
 Disconnect pole terminal to negative
pole (-).
 Unscrew the connection wires from the
batteries.
 Disconnect pole terminal to positive
pole (+).
 Loosen the holding strap.
 Remove the battery.
 Dispose of the used battery according
to the local provisions.

Start up

General notes
DANGER
Risk of injury! Switch off the appliance prior
to removing the waste container.
Note: Start the appliance only when the
hood is closed.
 Park the sweeper on an even surface.
16
 Switch off engine.
 Lock parking brake.
Inspection and maintenance work
 Check charging status of battery.
 Check side brush.
 Check roller brush.
 Shake off dust filter.
 Empty waste container.
Note: For description, see section on Care
and maintenance.
Danger
Long hours of using the appliance can
cause circulation problems in the hands on
account of vibrations.
It is not possible to specify a generally valid
operation time, since this depends on sev-
eral factors:
– Proneness to blood circulation deficien-
glows yellow
cies (cold, numb fingers).
– Low ambient temperature. Wear warm
glows green
gloves to protect hands.
– A firm grip impedes blood circulation.
– Continuous operation is worse than an
operation interrupted by pauses.
In case of regular, long-term operation of
the device and in case of repeated occur-
rence of the symptoms (e.g. cold, numb fin-
gers) please consult a physician.
 Release parking brake.
Start the motor.
 Turn the main switch to position "1".
Note: The roller brush and the side brush
will rotate.
Drive forward
 Pull the lever for forward drive.
Note: The drive speed for forward drive
can be adjusted steplessly depending on
the position of the lever.
Dry run
 Release the lever for forward drive. De-
vice comes to a halt.
Driving over obstacles
Driving over fixed obstacles which are 30
mm high or less:
 Raise bulk waste flap.
 Drive forwards slowly and carefully.
Driving over fixed obstacles which are
more than 30 mm high:
 Only drive over these obstacles using a
suitable ramp.
Danger
Risk of injury! If the bulk waste flap is open,
stones or gravel may be flung forwards by
the roller brush. Make sure that this does
not endanger persons, animals or objects.
CAUTION
Do not sweep up packing strips, wire or
similar objects as this may damage the
sweeping mechanism.
Note: To achieve an optimum cleaning re-
sult, the driving speed should be adjusted
to take specific situations into account.

Operation

Starting the machine
Drive the machine
Sweeping mode
5
-
EN
Sweeping with bulk waste flap raised
Note: To sweep up larger items up to a
height of 50 mm, e.g. cigarette packs, the
bulk waste flap must be raised briefly.
Raising bulk waste flap:
 Pull the lever for raising the bulk waste
flap.
Lowering the bulk waste flap:
 Release the lever for raising the bulk
waste flap.
Note: An optimum cleaning result can only
be achieved if the bulk waste flap has been
lowered completely.
Sweeping with side brushes
 Move the lever to lower the side brush
to the front. The side brush will be low-
ered.
Sweeping dry floors
Note: During operation, the waste contain-
er should be emptied at regular intervals.
Note: During operation, the dust filter
should be shaken off and cleaned at regu-
lar intervals.
 Close wet/dry flap
Sweeping damp or wet floors
 Open wet/dry flap.
Note: This protects the filter from moisture.
Battery display
The battery display shows the charging sta-
tus of the batteries during operation:
full
glows green
30% capacity remaining glows yellow
10% capacity remaining blinks red
Protection against total
glows red
discharge; the appliance
is switched off
Cleaning the dust filter
 Pull the handle of the filter clean-off out
several times and reinsert it.
Emptying waste container
DANGER
Risk of injury! Switch off the appliance prior
to removing the waste container.
Note: Make sure the seal strip is not dam-
aged while emptying the waste container.
Note: The max. load of the waste container
is 40 kg.
 Shake off dust filter.
 Pull lock bow of the waste container up-
ward.
 Pull out the waste container.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Km 75/40 w bp pack

Tabla de contenido