Lutron EcoSystem 5 Serie Instrucciones De Instalación

LED Driver Installation
Best Practices Guide
EcoSystem
TM
Driver Mounting
Mount driver flush against fixture to provide best heat transfer. Avoid mounting driver close to heat source such as fixture cover
plate or light source. Installer is responsible for ensuring that the driver case temperature does not exceed the maximum rated
temperature.
Tab Mounting – M Enclosure
Correct
Driver must be grounded by a mounting screw to the grounded fixture. Fixture must be grounded in accordance with local
and national electrical codes.
Power Wiring
WARNING: Shock hazard. May result in serious injury
or death. Disconnect power before servicing
or installing.
LDE Models: M Enclosure
N
Power Input
N/C
(Mains)
L
EcoSystemT / DALI
DA / E2
1,2
Digital Link
DA / E1
EcoSystem / DALI Digital Link Wiring
TM
Digital Link
Wire Size
Length (max)
2
4.00 mm (12 AWG) 800 m *
2.50 mm 2 (14 AWG) 500 m *
1.50 mm 2 (16 AWG) 300 m
2
1.0 mm 200 m
0.75 mm 2 (18 AWG) 150 m
* For DALI applications, the maximum
permissible link length is 300 m.
To EcoSystem / DALI Digital
TM
Link compatible devices
(up to 64)
Lutron Technical Support Hotline +44.(0)20.7680.4481
© 2015 Lutron Electronics Co., Inc. Lutron and ) are registered trademarks and EcoSystem is a trademark of Lutron Electronics Co., Inc.
5-Series
1
EcoSystemT / DALI must be
separated from mains wiring
by the following: 6 mm or
physical barrier.
2
EcoSystemT / DALI Digital
Link length is limited by the
wire gauge used for DA / E1
and DA / E2 as follows.
Driver
terminals
Incorrect
Driver Wiring
Wire Strip Length
For power, output, and digital terminals (DA / E1, DA / E2).
For proper wiring
Follow wiring schematic on driver being installed. Driver photos
are for reference only.
EcoSystem 5-Series, M Enclosure
TM
30 mm W × 25 mm H × 362 mm L
Load Wiring
Note: SELV output designed to withstand hot swap.
OEM Note
For best dimming performance, Lutron recommends electrical insulation with
50 / 60 Hz impedance of at least 12 MΩ and minimum breakdown voltage of
at least 1 500 V~ between LEDs and fixture chassis.
Wire Gauge
2
0.75 mm (18 AWG)
1.5 mm 2 (16 AWG)
2
2.5 mm (14 AWG)
2
4.0 mm (12 AWG)
Solid copper 0.75 –1.5 mm
(18 –16 AWG) wire
8.0 mm
–V (Black)
source
+V (Red)
See table below
Maximum Lead Length
200 mA –700 mA 710 mA –1.5 A
9 m 4.5 m
10.5 m 7.5 m
15 m 12 m
30 m 18 m
www.lutron.com
041468b 01/2015
2
LED
light
1.51 A –2.10 A
3 m
4.5 m
7.5 m
12 m