Troubleshooting - Glacier bay VWD5446BLS-2-HDU Guía De Uso Y Cuidado

Troubleshooting

Problem
Water dispenser
or dispensing
button is leaking
Water is not hot or
cold enough
Water dispenser
is not dispensing
water
Water dispenser
is noisy
Possible Cause
Small pin hole or crack in the
bottle, (common with recycled
water bottles).
Drain cap and silicone seal are not
secure.
Water was poured directly into
bottle support collar and
overflowed.
All the water in the tank has been
used.
The unit is unplugged.
"Kettle" Feature was not activated.
The circuit breaker in your home is
tripped or the fuse has blown.
Temperature limit tripped.
Thermostat needs to be adjusted
colder.
Empty water bottle.
Mineral deposits clogging tanks.
Possible air pocket.
Possible ice build up due to
thermostat set too cold.
Bottle making a gurgling noise as it
fills the tank.
Water dispenser is uneven.
Suggested Solution
Conduct water bottle leak test
outlined under "ANTI-LEAK
BOTTLE SUPPORT COLLAR".
Ensure seal is secure in drain plug
and tighten drain cap.
Drain by pressing dispenser taps.
Replace with full bottle and wait;
60 minutes for water to cool, 15
minutes for water to heat.
Plug it into the outlet.
Activate "Kettle" Feature by
pressing the button.
Reset the breaker or replace the
fuse.
Allow the temperature of the
hot water tank to cool for
approximately 15-30 minutes.
The temperature limit thermostat
will re-set automatically once
sufficiently cooled, and the
cooling system will reactivate
automatically. To operate the hot
water system, press the Kettle
Feature button.
Adjust thermostat between "MIN"
(cool) and "MAX" (colder) levels to
achieve desired temperature.
Replace with full bottle.
See Cleaning the Reservoirs.
Push down on the dispenser
buttons to prime the unit.
Unplug overnight, then reset.
Set thermostat to high, slowly
increasing based on your use and
need for cold water.
This is normal.
Make sure the dispenser is on an
even surface that can support its
full weight.