Remote Sensor; Getting Started; Insert Batteries - Oregon Scientific RMR203HG Manual Del Usuario

REMOTE SENSOR (FIG 3)
1
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch

GETTING STARTED

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see FIG
2).
2
3
LOCATION
Clock / alarm
Outdoor temperature
and humidity area

REMOTE SENSOR

4
The main unit can collect data from up to 3 sensors.
5
To set up the sensor:
1. Open the battery compartment (see FIG 3).
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP
Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not more
than 1.5 m (5 ft) and which can shield it from direct sunlight
or wet conditions for an accurate reading.
3
MEANING
Main unit batteries low
Sensor batteries low