Black+Decker LHT2220 Manual De Instrucciones página 9

Never hold the unit by the blade guard.
2. TRImmING NEW GROWTH –
(Figure 8) a wide, sweeping motion,
feeding the blade teeth through
the twigs is most effective. a slight
downward tilt of the blade, in the
direction of motion gives the best
cutting.
CAUTION:
Do not cut stems greater
than 3/4 inch (19mm). Use the trimmer
only for cutting normal shrubbery around
houses and buildings.
3. LEVEL HEDGES (Figure 9) – To obtain
exceptionally level hedges a piece of
string can be stretched along the length
of the hedge as a guide.
4. SIDE TRImmING HEDGES (Figure 10) –
Hold the trimmer as shown and begin at
the bottom and sweep up.
WARNING:
TO GUarD aGaINST
INJUrY, OBSerVe THe FOllOWING:
• READ INSTRUCTION MANUAL
BeFOre USING. SaVe INSTrUcTION
MaNUal.
• cHeck THe HeDGe FOr FOreIGN
OBJecTS SUcH aS WIre Or
FeNceS BeFOre eacH USe.
• KEEP HANDS ON HANDLES. DON'T
OVerreacH.
• DO NOT USE UNDER WET CONDITIONS.
8
0-15
9
10
9
CAUTION:
BLADE MAY COAST AFTER TURN OFF.
DANGER:
KEEP HANDS AWAY FROM BLADES.
WARNING:
remove battery pack before servicing, cleaning or
removing material from the gardening appliance.
The cutting blades are made from high quality,
hardened steel and with normal usage, they will not
require resharpening. However, if you accidentally
hit a wire fence (figure 11), stones, glass or other
hard objects, you may put a nick in the blade. There
is no need to remove this nick as long as it does not
interfere with the movement of the blade. If it does
interfere, remove the battery and use a fine toothed
file or sharpening stone to remove the nick. If you
drop the trimmer, carefully inspect it for damage.
If the blade is bent, housing cracked, or handles
broken or if you see any other condition that may affect the trimmer's
operation contact your local Black+Decker Service center for
repairs before putting it back into use.
Fertilizers and other garden chemicals contain agents which greatly
accelerate the corrosion of metals. Do not store the unit on or adjacent
to fertilizers or chemicals.
With the battery removed, use only mild soap and a damp cloth to
clean the unit. Never let any liquid get inside the unit; never immerse
any part of the unit into a liquid. Prevent the blades from rusting by
applying a film of light machine oil after cleaning.
This class B digital apparatus complies with canadian IceS-003.
This device complies with part 15 of the Fcc rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a class B digital device, pursuant to Part 15 of the Fcc
rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
11