Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Product may vary slightly from what is illustrated.
1. Food chute
2. Multifunctional feed chute
† 3. 12-cup workbowl cover (Part # FP3000FBS-02)
† 4. 12-cup workbowl (Part # FP3000FBS-07)
5. Base
† 6. 4-cup workbowl (Part # FP3000FBS-08)
† 7. Food pusher (Part # FP3000FBS-01)
† 8. Reversible slicing/shredding disc (Part # FP3000FBS-03)
9. Center post with interlocking safety latch
† 10. Dough blade (Part # FP3000FBS-04)
† 11. Large stainless steel chopping blade (12-cup workbowl) (Part # FP3000FBS-06)
† 12. Small stainless steel cutting blade (4-cup workbowl) (Part # FP3000FBS-05)
† 13. Skid-resistant feet
14. Control panel
Note: † indicates consumer replaceable/removable parts
4
How to Use
This product is for household use only.
USAGE AS A FOOD PROCESSOR
GETTING STARTED
• Remove all packing material, and any stickers from the product. Remove and save
literature.
• Please go to www.prodprotect.com/applica to register your warranty.
Note: Wash all removable parts as instructed in CARE AND CLEANING section of this
manual. (See directions for inserting and removing the center post with interlocking
safety on page 5.)
Caution: Handle chopping blades and slicing/shredding disc very carefully. They
are very sharp.
• Select a level dry countertop where the appliance is to be used allowing air space on all
sides to provide proper ventilation for the motor.
ASSEMBLING YOUR FOOD PROCESSOR AFTER WASHING
Important: Always make sure your food processor is unplugged before starting to
assemble.
INSERTING AND REMOVING CENTER POST WITH INTERLOCKING SAFETY LATCH
This part of the large wokbowl is removable
1. Place the workbowl on a flat surface with the bowl turned upside down.
2. Hold the workbowl in place by the handle. Grasp the opaque tabs on
the black based center post with interlocking safety latch and rotate the
center post counterclockwise until the lower tabs are free. Lift the post
out (A).
3. To return to its original position, invert the workbowl and place center
post into opening in bottom of workbowl and press down until it rests
A
flat against the bottom of the workbowl. Turn the tabs clockwise until
tabs snap into place.
LOCKING THE WORKBOWL IN POSITION
1. Attach center post to workbowl (as directed above). Place the
workbowl on the base of the food processor with handle turned to the
left of the locking mechanism (
2. Hold handle and rotate workbowl counterclockwise toward the lock
signage (
) until it clicks firmly into place.
B
Note: Be sure to lock the workbowl in place before attaching the blades
and cover.
LOCKING THE COVER
1. Place cover over workbowl with the small latch to the left of the
workbowl handle (C).
2. Hold food chute and rotate cover counterclockwise until cover locks
into place.
3. Place the multifunctional feed chute into the food chute on top of the
cover with the small single clear plastic arm facing the handle on the
C
workbowl. Push down until the feed chute rests at the bottom of the
food chute.
Important: For your protection this appliance has an interlock system.
The processor will not operate unless the cover and multifunctional feed chute
is properly locked in place.
) over the unlock symbol (
) (B).
5
Publicidad
Tabla de contenido
