Maintenance; Lighting Instructions; Burner Cover Assembly - CSA WT17IL Manual Del Usuario

The flames should look like those in Figure 10. To clean the
burner, use a soft brush after the burner has cooled
completely. Never use a vacuum cleaner on the burner. It is
recommended to store the fire pit indoors during winter if it
will be subjected to freezing temperatures. The LP cylinder
must be disconnected and removed from the appliance
before the appliance can be stored indoors.
Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
IGNITER BUTTON
1. Read instructions before lighting.
2. Push in on the control knob and turn to the ON position.
3. With the control knob pressed in, also push the igniter button to light the burner. Release
the control knob after 15 seconds. If the burner does not light, wait 5 minutes, repeat.
4. Adjust the flame to the desired height by using the control knob. See Figure 11.
Place the burner cover on the table top as shown in Figure 12.
WARNING: BEFORE PLACING THE BURNER COVER ON, MAKE SURE
THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER HAS
COMPLETELY COOLED DOWN.

MAINTENANCE

LIGHTING INSTRUCTIONS

BURNER COVER ASSEMBLY

Figure 11
Figure 12
10
Figure 10
CONTROL KNOB