Specifications; Installation Requirements; Electrical Requirements - Wolf M Serie Manual Del Usuario

Specifications

Installation Requirements

The warming drawer must be installed with a Wolf drawer
front, avail able through an authorized Wolf dealer. For
local dealer information, visit the find a showroom section
of our website, wolfappliance.com. Specific installation
instructions are included with the drawer front.
The warming drawer can be installed in a standard or flush
inset application (excludes L series drawer front).
Finish the edges of the opening. They may be visible when
the drawer is open.
For standard installations, the face trim will overlap stiles
and rails. Refer to the chart below.
For flush inset installations, a minimum 1/8"
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
An anti-tip block must be installed to prevent the warming
drawer from tipping forward when opened.
INSTALLATION REQUIREMENTS
BASE SUPPORT
Warming Drawer
TRIM OVERLAP
Top, Bottom, and Sides
4 | Wolf Customer Care 800.222.7820

Electrical Requirements

Installation must comply with all applicable electrical codes.
Locate the electrical supply flush with the back wall and
within the shaded area shown in the illustrations on the
following pages. For ease of installation, the electrical
supply for the warming drawer can be placed in an adja-
cent cabinet within reach of the power cord.
IMPORTANT NOTE: When installed outdoors, a ground
fault circuit interrupter (GFCI) is required to reduce the risk
of electrical shock.
ELECTRICAL REQUIREMENTS
Electrical Supply
reveal is
(3)
Service
Receptacle
Power Cord
MIN
200 lb
(90 kg)
5/8"
(16)
RATING
PLATE
Rating plate location
grounded, 120 VAC, 60 Hz
15 amp dedicated circuit
3-prong grounding-type
3'
(.9 m)