Charging The Battery; Important Safety Instructions - NX CEH9109 Instrucciones De Operación

CHARGING THE BATTERY

1 • Plug the charger into the AC outlet.
Place magnetic battery connector cable (or clip battery connector cable) to the battery connectors.
2 • When connected with the battery in 2 seconds, the Red and Green lamps will start to flash simultaneously. The Red lamps will
be lit after flashing in 3 times to start charging.
3 • a. When charging is completed, the green lamp will be lit, then the charger will be into the trickle charge stage keeping
the battery in full charge status.
b. Charging will not start if the battery pack is too cool, or the battery pack has not been used for a long time, the Red and
Green lamps will keep flashing. Pls. just press "RESET", the charger will re-charge in 2 seconds later. After several minutes,
the Red and Green lamps flash again, pls. repeat to press "RESET" again. If press "RESET" in 5 times later, the lamps still
on flashing, it means the battery pack is too old or defective. Pls. change a new battery pack.
c. After a few minutes during the charging procedure, the Red and Green lamps were flashed, it means the voltage of battery
pack is lower than standard, pls. just press "RESET", the charger will re-charge in 2 seconds. If the lamps still flash in a
period, it means the battery pack is too old.
Note:
• a. If the battery pack has not been used for a long time, it is better to press 2~3 times of "RESET" button to repeat charging.
Then the battery pack will be warm up for better charging status.
• b. When charging a cool battery pack below 5°C in a warm place, leave the battery pack at the place and wait for more than
one hour to warm up the battery to the level of the ambient temperature. Otherwise battery pack may not be fully charged.
• c. To reduce risk of electric shock for the charger, pls. remove the magnetic battery connectors one by one separately
from battery pack when finish charging and put them back on the seat of charger. (See Fig. 2).

IMPORTANT SAFETY INSTRUCTIONS

1 • Before using battery charger, read all instructions .
2 • To reduce the risk of injury, charge only battery pack of cordless
power tools.
3 • Do not expose charger to rain or snow.
4 • To reduce risk of damaging the electric plug and cord, pull by
plug rather than cord when disconnecting charger.
5 • Make sure cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damaged or stress.
6 • An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result in a
risk of fire and electric shock.
Fig 1 Fig 2
7 • Do not disassemble charge, take it to a qualified serviceman
when service or repair is required. Incorrect reassembly may
result in a risk of electric shock of fire.
8 • To reduce the risk of electric shock, unplug charger from outlet
before attempting any maintenance or cleaning.
9 • Do not charge battery pack when the temperature is below
0°C or above 40°C.
10 • Avoid dangerous environment. Do not use charger in damp
or wet locations.