When opening the container
with the small opening, use it
near the opening of the water
or ice dispenser as close as
possible.
ICE STORAGE BIN
The ice bin stores the ice cubes made by the ice maker.
If you need remove the Ice storage bin, please follow the
next steps:
NOTE: Use both hands to remove the ice bin to avoid
dropping it. If the ice bin does not slide into place easily,
twist the drive device slightly.
• Hold the ice storage bin as shown in the right figure
and pull it out while slightly lifting it
2
1
• To assemble the ice storage bin, push it
slightly lifting it
.
Make sure it is fully engaged into the auger drive
USING YOUR REFRIGERATOR
.
while
.
15
ICEMAKER
COVER
If you need acces to the Icemaker, follow these steps:
• Remove the ice storage bin. See ICE STORAGE BIN
for reference.
• Lift the icemaker cover
the figure below.
2
SNACK PAN
Air is entered in the refrigerator when the door is open,
unaffected cold meat due to the position of this tray.
To remove the
snack pan
•
compartment a bit to the front
of the snack pan compartment later raises a little the
snack pan compartment until it leaves the top of the
shelf as shown in
, and take it out.
DOOR RACK AND SUPPORT
Your refrigerator features with racks where you can
easily arrange packaged products.
Lift the door rack holding both sides
•
direction.
and pull it out
as shown in
1
cover, pull out the
snack pan
, then lift the front part
and pull it out in