Infosec 650 XP SoHo Guía De Usuario página 5

7 . I N S T A L L A T I O N A N D O P E R A T I O N
1. Checking
When you receive your equipment, open the packaging and check that your UPS has not
been damaged. The packaging includes:
a UPS unit, 2 IEC output cables and a user guide. In the event of damage, please submit a
standard claim to the after-sales service department.
2. Charging the batteries
This unit is shipped from the factory with its internal battery fully charged, however, some
charge may be lost during shipping and the battery should be recharged prior to use. Plug
the unit into an appropriate power supply and allow the UPS to charge fully by leaving it
plugged-in, with no load, for at least 8 hours.
3. Where to set up
The UPS has been designed to operate in a protected environment, at temperatures
between 0°C and 40°C and at a humidity level ranging between 0% and 90% (no
condensation).
Do not obstruct the ventilation slots. Install the unit in an environment which is free from
dust, chemical vapours and conductors.
Moreover, in order to avoid any interference, keep the UPS at least 20cm away from the
CPU (central processing unit).
4. Connection
Check on the identification plate at the back of the UPS that the power supply is compatible
with network voltage and that the device is powerful enough to protect the given power load.
Plug the UPS into a 2-pole, earthed outlet (use the original power cable of your computer or
it is recommended to use a power cable 2P+E/CEE22/10A). Then, use the 2 IEC cables to
connect one computer-related device to each of the power outlets supplied on the back of
the UPS. You can also connect a device that does not require backup time, such as a
printer, to the surge protected and filtered outlet.
5. On/Off
To turn the UPS unit on, lightly press the power switch. To turn it off, press the power switch
again.
6. DC Start
XP units are equipped with an integrated DC start function. To start the UPS in the absence
of a power supply and with a full battery, press the button.
7. Power Saving Function
XP range is equipped with a Power Saving Function. If no load connects to the UPS, it will
automatically shut down after 5 minutes to save energy during a power failure. The Power
switch must be kept in the 'ON' position, otherwise, the UPS will be disabled and your
equipment will not be protected during a power failure.
5
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr – 09 05 04 206 02