Progress Lighting Airpro P2553 Manual De Instalación página 11

Installing the Light
Kit/ Glass Bowl
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Loosen but do not remove three of four
mounting screws from the light kit adaptor
below the fan motor assembly; remove one
mounting screw. (Figure 11)
2. Connect the blue and white wires exiting
the light kit adaptor with the black and
white wires from the light kit assembly by
engaging the molded adaptor plugs (blue to
black; white to white).
3. Carefully tuck connectors into the light
kit adaptor. Position the light kit assembly
onto the light kit adaptor, aligning each of
the four holes. Rotate the light kit assembly
clockwise to engage the three mounting
screws with the three key hole slots, tighten
the screws. Re-install the one mounting
screw that was removed in step 1 and
tighten firmly.
4. With power off, install the two LED bulbs
by screwing into the light bulb sockets.
(Figure 12)
5. Place the glass shade into the light kit
assembly, aligning the three flat areas
on the top flange of the glass shade with
the three raised dimples in the light kit
assembly. Turn the glass shade clockwise
until it stops. (Figure 12)
PERIODICALLY CHECK THE SHADE IS SEATED
FULLY CLOCKWISE IN THE LIGHT KIT PAN
ASSEMBLY.
ALLOW THE BULBS TO COOL COMPLETELY
BEFORE TOUCHING OR REPLACING TO AVOID
ACCIDENTAL BURNING OF THE SKIN.
Raised
Dimples
Bulbs(2)
Glass
(Provided)
Flat Area
Figure 11
Light Kit
Assembly
Figure 12
8.