Ibx R10 Manual De Instrucciones página 4

Operation
Operating procedure
1. The diagram of the pump system is shown as above.
2. Once all tubes have been connected to Inlet (1) Outlet (2) properly then activate the pumping
function by pressing (3) on/off button.
3. To adjust vacuum of the pump, an optional vacuum regulator/ moisture trap is needed.
Warning: When pump is used in water filtration, please do not make the liquid level of flask exceed
safety level. Failure to comply could result in serious damage to the pump and void the warranty. If
it occurs, please contact the distributor immediately for service.
Setup moisture trap (Option)
Moisture trap (Vacuum regulator) is an optional item that is used to adjust vacuum and absorb
moisture and particle.
The flow chart of installing vacuum regulator/moisture trap
Remove the screw at side of cylinder
head with a spanner.
Remove tier connector with a spanner.
Fix the screw removed from step 1
at the location of tier connector
removed from step 2.
Fix the moisture trap at the location
of the screw removed from Step 1.
Finished.
4