Resumen de contenidos para firegear Outdoors RTF-L42
- Página 1 Ready-To-Finish Fire Pit Cabinet Assembly Instructions For Part Numbers: RTF-L42 RTF-L48 RTF-L60 RTF-L72 Top Panel with Burner Cutout Templates Adjustable Burner Frame Side Panel Back Panel Front Panel Side Panel v100813...
- Página 2 Step 1 - Assemble the walls of the fire pit cabinet Locate one fire pit panel with the attached mounting tabs and one panel without tabs as shown in Fig. 1a. Ubique un panel del “FirePit” con las tabs de montaje adjunta y un panel sin tabs como se muestra en Figura 1a. Figure 1a Panel with Mounting Tabs...
- Página 3 Repeat the previous step to attach the third side of the fire pit as shown in Fig. 1c. Again, use the ¾” screws includ- ed with the kit. Repita el paso anterior para colocar el tercer lado de la “Firepit” como se muestra en figura 1c. De nuevo, utilice los tornillos ¾”...
- Página 4 Step 2 - Assemble burner support frame Refer to the manufacturer’s specifications to determine the cut-out size for the model of burner pan to be installed. Lay-out and scribe the “cut-out” size of the burner pan onto the top tubes of two opposing exterior panels. Install the two burner supports as shown in Fig.
- Página 5 Step 3 - Complete burner cutout On the top panels, there are two pre-marked burner cut-out sizes provided (see Fig. 3a). Using a grinder with a diamond blade, cut out the appropriate sized rough opening that matches the cutout specifications as shown in the installation instructions for your burner (see Fig.
- Página 6 Use the 1¼”, grey coated screws that are included in the kit to fasten the top panels to the outer perimeter framing and burner supports. It is best to pre-drill the holes through the board material and into the steel tubng usng a 1/8” drill bit prior to installing the screws.