Electrical Installation; Maintenance And Cleaning - Oase InScenio 230 Instrucciones De Uso

- GB -
Safe operation
− Operation of the unit is only permitted with the protection hood fitted. In this manner, connections and plugs are
protected from rain and splash water (type of protection IP X4).
− The unit, the connections and plugs are not water-proof and must not be routed or installed in water.
− Never operate the unit if either the electrical cables or the housing are defective!
− Do not carry or pull the unit by its electrical cable.
− Route all cables such that damage is excluded and nobody can trip over them.
− Never open the unit housing or its attendant components, unless this is explicitly required in the operating instruc-
tions.
− Only use original spare parts and accessories for the unit.
− Never carry out technical modifications to the unit.
− Only have repairs carried out by customer service points authorised by OASE.
Installation
How to install the unit:
− Remove the protection hood from the unit.
− Set-up the unit horizontally and water-protected, at a dry location, at least 2 m from the edge of the pond (B, C).
− Fully insert the ground stake (3) into the soil.
− Place the unit onto the ground stake (insert the ground stake in a corresponding mounting).
− Check its stability.

Electrical installation

This is how to connect the power supply:
− Push the female connector of the power supply (4) onto the unit plug (5).
The connection is made on the unit rear (D).
Start-up
Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures:
− Only operate the unit with the protection hood fitted.
− Ensure that the unit is installed water-tight with a safety distance from the water of a minimum of 2 m.
Connect the units to the power supply distributor
This is how to connect your OASE unit to the power supply distributor:
− If necessary, remove the protection hood from the power supply distributor.
− Make sure that your OASE unit may be connected to this socket. For this purpose, consult the instructions of use of
the unit you wish to connect.
− Connect the unit.
− Always use the pull relief (E, 6) provided on the unit for the connection cables.
− Refit the protection hood to the unit.
Supplemental instructions for operation
− Do not connect any additional FM-Master units or portable multi-outlet power strips to the device.
− The device is only de-energised when the plug of the mains supply cable is unplugged.

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures: Switch off the mains voltage prior to carrying out work on the unit.
Cleaning the unit
Clean the unit with a soft, clean and dry cloth. Never use aggressive cleaning agents or chemical solutions. These can
attach the housing surface or impair the function.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
6