Fenix V27 Manual De Instrucciones página 29

Example 2: Z1 (Regulation Zone)
Then the module should answer you with a SMS like this:
Z1= Living
Status = Ok
Room = 21.4C
SetPoint = 21.0C
Mode = AUTO
Heating = 1
Once this message received you will have the possibility to send back it with a different setting point
temperature or working mode by return the text of the SMS received and forward it with the only changes
marked in green on the example below.
Example of modification
Z1= Living
Status = Ok
Room = 21.4C
SetPoint = 20.0C
Mode = MANUAL
Heating = 1
You should receive a confirmation SMS with your last change few minutes after.
Name of the zone "Living", the name displayed is the name chosen on your V24
Central unit. (The name will be always received in GB language)
Status of the zone,
Ok => to say that the zone work properly.
Error => to say that the zone is faulty (thermostat batteries, receiver problem
Actual room temperature in °C.
Actual setting point of the room in °C.
Note: You will have the possibility to change the setting point.
Possible change "05.0°C to 35.0°C"
Actual working mode. (Auto, Manual, Antifreeze, OFF)
Heating indication. (1 = Heating demand / 0 = No heat demand)
No possibility for change.
No possibility for change.
No possibility for change.
New setting point temperature "20.0C" for Z1.
Change possibility between 5.0 to 37.0C
New working Mode possible:
Text available V24 corresponding Symbol
MANUAL
AUTO
ANTI-FREEZE
OFF
No possibility for change.
Yes
Yes (Override 2H)
Yes
Non applicable
29
...)
Setting point change possibility