Bosch GNA 2,0 Manual De Instrucciones página 6

GNA20_bu_3609929084_t.fbk Seite 7 Montag, 9. August 1999 4:58 16
Product Specifications
Nibbler
Order number
Power input
Power output
Load stroke rate
Maximum cutting thickness*
Width of cut
Weight (without accessories)
Protection rating
* referred to sheet metal with 400 N/mm
Noise/Vibration Information
Measured values determined according to EN 50 144.
Typically the A-weighted sound pressure level of the
tool is 82 dB(A). The noise level when working can
exceed 85 dB(A).
Wear ear protection!
The typical weighted acceleration is 3.0 m/s
Product Elements
1 On/Off switch
2 Housing
3 Sleeve nut
4 Clamping screw
5 Die
6 Nut
7 Punch
Accessories
Punch
For curved cutting . . . . . . . . . . . . . . . 2 608 639 013
For straight cutting . . . . . . . . . . . . . . . 2 608 639 016
Universal . . . . . . . . . . . . . . . . . . . . . . 2 608 639 022
Die
Universal . . . . . . . . . . . . . . . . . . . . . . 2 608 639 900
For corrugated and profile sheet
metal to 1.2 mm. . . . . . . . . . . . . . . . . 2 608 639 021
Punch and Die Set
For corrugated and profile sheet
metal to 1.2 mm. . . . . . . . . . . . . . . . . 2 608 639 902
Not all the accessories illustrated or described are
included in standard delivery.
Intended Use
The machine is intended for the cutting of sheet metal
GNA 2.0
without material deformation and is suited for straight
cuts, cutouts and narrow curved cuts.
0 601 530 1..
[W] 500
[W] 270
-1
[min ] 1500
[mm] 2.0
[mm] 6
[kg] 2.0
/ II
2
2
.
For Your Safety
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein
followed.
Before using for the first time, ask
for a practical demonstration.
In addition, the general safety
instructions in
booklet must be followed.
The machine must not be damp
and must also not be operated in
damp surroundings.
If the cable is damaged or cut through
while working, do not touch the cable
but immediately pull the mains plug.
Never use the
damaged cable.
Wear safety glasses, protective gloves
and sturdy shoes.
Connect the mains plug only when the tool is
switched off. After using, pull the mains plug.
Always direct the cable to the rear away from the
machine.
Before any work on the machine itself, pull the
mains plug.
Do not carry the machine by the cable.
Always clamp down the material to be worked.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance.
Keep punch and die free from material chips.
Persons under 16 years of age are not permitted to
operate this machine.
Bosch can assure flawless functioning of the
machine only when original accessories are used.
are strictly
the enclosed
machine with a
7