Important Safeguards - Hamilton Beach Wave Station Manual Del Usuario

840208401 ENv01.qxd:Layout 1
When using electrical appliances, basic safety precautions should always be followed, including the following:
1. Read all instructions.
2. To protect against risk of electrical shock, do not put cord,
plug, base, or motor in water or other liquid.
3. Close supervision is necessary when any appliance is used
by or near children.
4. Unplug cord from outlet when not in use, before putting on
or taking off parts, and before cleaning.
5. Avoid contact with moving parts.
6. Do not operate any appliance with a damaged cord or plug,
or after the appliance malfunctions, or is dropped or damaged
in any manner. Call our toll-free customer service number for
information on examination, repair, or electrical or mechanical
adjustment.
7. The use of attachments, including canning jars, not
recommended or sold by the appliance manufacturer
may cause a risk of injury to persons.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter or touch
hot surfaces, including stove.
10. Keep hands and utensils out of blender jar while blending to
reduce the risk of severe personal injury and/or damage to
blender. A rubber spatula may be used but must be used
only when blender is not running.
2
12/21/11 4:25 PM Page 2

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS!
11. Blades are sharp; handle carefully – especially when
assembling, disassembling, or cleaning inside blender jar.
12. Do not use a broken, chipped, or cracked blender jar.
13. Do not use broken, cracked, or loose cutting blade assembly.
14. Always operate blender with lid in place.
15. When blending hot liquids, remove center-piece of two-piece
lid. Hot liquids may push lid off jar during blending. To prevent
possible burns: Do not fill blender jar beyond the 3-cup (750-ml)
level. With the protection of an oven mitt or thick towel, place
one hand on top of lid. Keep exposed skin away from lid. Start
blending at lowest speed.
16. Do not leave blender unattended while it is operating.
17. Check that the control is OFF before plugging cord into wall
outlet. To disconnect cord, turn the control to OFF . Then
remove plug from wall outlet.
18. Do not use appliance for other than intended purpose.