Lcd Backlight Button; Automatic Power Off - koban KPA-01T Manual Del Usuario

EN
6.14 Relative
- Press the REL button to zero the display. "REL" will appear in the display. The displayed reading
is now the actual value less the stored "zero" value.
- Press the REL button to view the stored value. "REL" will flash in the display.
- To exit this mode, press and Hold the REL button until "REL" is no longer in the display.
6.15 MAX/MIN
Press MAX/MIN key the maximum and minimum values are measured. This mode is activated on
each measurement except for continuity test, diode test, capacitance test, frequency test and duty
cycle test.
This mode is disabled keeping pressed MAX/MIN key or moving the rotary switch.
6.16 HZ/%
With rotary switch on KZ%, Voltage, Current, positions, the Hz% key permits to select the frequen-
cy test (Hz) or the duty cycle test (%).
6.17 Flash Light Button
Press the button on the flashlight to turn on the flashlight. Press the button again to turn off the
linetine.

6.18 LCD Backlight Button

The LCD is equipped with backlight for easier viewing, specially in dimly lit áreas. Press the back-
light button to turn the backlight on. Press again to turn the backlight off. Note that the meter does
have an auto power off feature as described below.

6.19 Automatic Power OFF

In order to conserve battery life, the meter will automatically turn off after approximately 15
minutes. To turn the meter on again, turn the function switch to the OFF position and then to the
desired function position.
KPA-01T
CLAMP METER TRMS
36 / 50