SEVERIN KS 9824 Instrucciones De Uso página 12

∙ The unit must not be installed inside a cupboard; when
positioning the unit, also ensure that it is not placed directly
underneath a shelf or any other similar object.
∙ Ensure that there is suffi cient space in front for the door to
open to 160°.
∙ In the case of uneven fl oors, the adjustable feet at the front
can be used to compensate and ensure optimum stability.
Ventilation
Ensure that there is enough space around the unit so that the air
circulation round and behind it is not obstructed. (rear and sides 5
cm, top 10 cm.)
Reversible door
The design provides for the door to be reversed, i.e. for right-
hinged (default installation) to become left-hinged.
Warning: Always disconnect the unit from the mains before
any maintenance or repair work is carried out.
1. Remove the two screw covers (11) and the screws (10).
2. Remove the entire top panel (9).
3. Remove the three threaded bolts (6) securing the hinge
plate (5) on the right-hand side.
4. Carefully lift up the door and place it on a suitable surface
to protect it from scratches.
5. Take off the protective corner-piece (7) and re-fi t it in the
groove on the right-hand side, pushing it fi rmly down.
6. Remove the hinge pin from the hinge plate and screw it
back in from the opposite side.
7. Remove the two screws from the left-hand side in the
hinge plate mounting and re-fi t them on the right.
8. Remove the three screws (1) holding the lower hinge plate
(2) on the right-hand side.
9. Remove the hinge pin from the lower hinge plate and re-fi t
it in the next hole.
10. Remove the adjustable foot (4) from the left-hand side and
re-fi t it on the right.
11. Attach the lower hinge plate (2). (Do not tighten the
screws for the moment; this should only be done once the
12
All manuals and user guides at all-guides.com
12. Replace the door in its new position. Ensure that the hinge
13. Attach the upper hinge plate (5) (removed earlier in step 3)
14. Adjust the closed door to its proper position and tighten
15. Replace the top panel (9).
16. Replace the screws (10) und the screw covers (11) in the
17. Put the unit back in its intended position and wait for about
Temperature control
The temperature control automatically regulates the
temperature inside the different compartments.
Min
Normal
Max
Following a power interruption, or if the unit has been switched
off on purpose, it may take 3 to 5 minutes before it switches
on again.
Note: The operating temperature in the freezer largely depends
on factors such as the ambient temperature and that of the
food to be newly frozen. It also depends on how often the door
is opened and how long it remains open. If necessary, the
temperature control setting may be adjusted accordingly.
Freezing and storing food
∙ With an operating temperature of –18°C and below, the
∙ To ensure that nutritious elements such as vitamins are
∙ Prior to freezing, fresh food (e.g. meat, fi sh, minced meat)
∙ When storing pre-frozen food, strict attention should be
∙ When buying frozen food, verify that the food is properly
door is in its proper closed position.)
pin is inserted into the guide bushing (hole) on the lower
part of the door frame.
on the left-hand side. Ensure that the hinge pin is inserted
into the guide bushing (hole) on the upper part of the door
frame.
the screws of the upper and lower hinge plates.
top panel (9).
two hours before connecting it to the mains.
cold setting
colder (normal)
setting
coldest setting
various freezer compartments can be used to store frozen or
pre-frozen food for several months, to make ice cubes and
to freeze fresh food.
not lost, fresh food should be deep-frozen right through as
quickly as possible. Caution: Do not exceed the maximum
freezing capacity per day. The product data sheet contains
details of the maximum daily freezing capacity. Spread it out
well in the freezer compartment and avoid contact with food
that has already been frozen.
should be divided into smaller portions suitable for use after
thawing).
paid to the manufacturer's information provided on the
packaging. If no such information is to be found, however, a
storage period of 3 months from the date of purchase must
not be exceeded.
frozen, and that the packaging does not show any sign of
damage.