SECO-LARM ENFORCER SM-216Q Manual

SM-216Q
Surface-Mount Wide-Gap
Contacts
Manual
Installation:
Please read manual before the installation.
:
1. Mount the contact above the door or
window on the frame. For doors, ensure
that the mounting is farthest from the
hinged side of the door.
2. Connect two wires to the contact
terminals and to the alarm control panel.
3. Mount the magnet on the door/window so
that it will face the contact. Be sure that
the gap between the contact and magnet
does not exceed 2
NOTES:
Contact and magnet must be installed on
1.
the protected side of the door or window.
Spacers are included for difficult or
2.
misaligned installations.
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service
for one (1) year from the date of sale to the original customer.
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change
specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their
respective owners. Copyright © 2019 SECO-LARM U.S.A., Inc. All rights reserved.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800 Email: sales@seco-larm.com
/ " (70mm).
3
4
U.S.A., Inc.
®
Features:
 Operating voltage: 12~24 VDC
 Wide gap
 Surface screw mount
 Integrated mounting holes
 Reed switch is SPST deactivated rhodium
on gold under-plating
 2
/ " (70mm) Gap
3
4
 For closed-loop circuits
 Limited lifetime warranty
Type: S
49J5
Parts List:
10x Contact Switches
20x Spacers
Protected side of door
Website: www.seco-larm.com
10x Magnets
1x Manual
Alarm
Control
Panel
Hinge side
of door
®
PITSW1
MI_SM-216Q_190206_ML.docx