Battery Installation - Krown TRS-100 Manual De Instrucciones

BATTERY INSTALLATION

TRS-100 Pager
Install one 8.4V rechargeable battery into the battery compartment in
the back of TRS- 100 pager. The batteries are used for operation. They
power the TRS-100 pager for approximately 48 hours standby. Do not
use Alkaline batteries, they will damage your TRS-100 pager.
Setting up the Tactile Phone Signaler
TRS-100 Transmitter
1. Plug the TRS-100 transmitter into the 2nd telephone jack of a
telecommunication device. If your telecommunication device
does not have an available jack for use, then use a telephone
duplex adapter.
2. Turn on the transmitter by pushing the switch up on top.
TRS-100 Pager
1. Locate the On/Off switch on the top of the pager. The "ON"
position is located the closest to the side of the top. Push the
switch to "ON" position to turn it on.
2. You can wear it by using the belt clip on the pager. It vibrates
when the transmitter is activated by an incoming call.
Charging the pager
When the battery is getting low, one LED on the top will fl ash and
vibrate in pulse pattern. Then you should charge your pager with the
TRS-100 adapter.
When the adapter is connected for charging, the low battery LED on
top will turn on to indicate that the battery is in charging condition. Al-
low at least 4 hours of charging before using the pager.
6