Publicidad
Idiomas disponibles
Idiomas disponibles
Service:
- The appliance has been oiled in ori-
gin. In order to maintain the applian-
ce in a good operation conditions we
suggest greasing the blades every
time you clean it by putting a few
drops of oil on the ends of the blade,
and finally switching on the appliance
during a few seconds.
- It is recommended to replace the
outer foil once per year.
- It is recommended to replace the
inner cutter once every two years.
- Make sure that the appliance is
serviced only by specialist personnel,
and that only original spare parts
or accessories are used to replace
existing parts/accessories.
- Any misuse or failure to follow
the instructions for use renders the
guarantee and the manufacturer's
liability null and void.
Charging the battery
Caution: A new battery is not fully
charged and must therefore be char-
ged before the appliance is used for
the first time.
- Charge the battery at an atmosphe-
ric temperature of between 4 and
40ºC.
- Make sure that the power is off
before charging.
- Connect the USB interfaces of
shaver and charger by data line, then
plug the adaptor (K) into the mains
(Fig. 1)
- A pilot light will come on to indicate
that the appliance is being charged.
Approximately 8 hours are needed
for a complete charge of the battery.
Never attempt to over charge the
battery (although it is recommended
Manual
17
that the first charge of the battery be
of 10 hours in duration).
- When the battery is charged dis-
connect the adaptor from the mains
supply.
NB: Do not use the appliance while it
is connected to the charger.
USB charge
- Please make sure that the power is
off before charging.
- Connect the USB interfaces of
shaver and computer by data line for
charging (Fig. 2)
- A pilot light will come on to indicate
that the appliance is being charged.
Approximately 8 hours are needed
for a complete charge of the battery.
Never attempt to over charge the
battery (although it is recommended
that the first charge of the battery be
of 10 hours in duration).
- When the battery is charged discon-
nect the computer data line.
NB: Do not use the appliance while it
is connected to the charger.
Instructions for use
Before use:
- Make sure that all the product's
packaging has been removed.
- Ensure that the selected tension on
the voltage selector coincides with
the tension of the mains.
- Before using this product for the
first time, it is important to make a
full charge of batteries.
Use:
- Remove the protective cap (A).
- Turn the appliance on, by using the
on/off switch.
18/07/11 19:12
Publicidad
