Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. CONNECTION AND MAINTENANCE OF VENTILATION (OPTIONAL)
The control unit and the plant must be installed and connected by authorized personnel according to the standards
in force. (see chapter GENERAL REMARKS).
ATTENTION: the control unit and the feeding cable must not be in contact with hot parts.
On our products, it is possible to install Optional ventilation kits suitable to improve the distribution of heat by ventilation only
either of the installation room or of the adjacent local (see chapter EXTERNAL AIR INTAKE).
For the installation of the Forced Ventilation Kit, follow the given instructions. (see chapter VENTILATION HOOD OR
ADJACENT LOCAL).
The Kit is made up of a centrifugal fan, a lighting and adjustment control unit, and a (TM) thermostat that lets the fan start
when the device is properly heated and lets it stop when the fan is partially cold.
The lighting and the adjustment is carried out through the proper standard supplied control unit that has to be installed far
from any direct heat source.
CONNECTION (see chapter OPTIONAL VENTILATION KIT):
Connect the feeding cable of the switchboard with an electronic bipolar switch respecting at least a 3 mm distance between
the contacts (power supply 230V~ 50 Hz, it is necessary to provide for the correct connection to the grounding plant).
WARNING: The COMMAND must be connected to the mains with a differential line cut-off switch according to the regulations
in force. Correct operation of the command is assured only for the proper motor for which it has been manufactured. Improper
use relieves the manufacturer from each responsibility.
MANDATORY: cable out of seeing !
6
6018090 KIT VENTILAZIONE OPTIONALE
TECHNICAL SPECIFICATIONS
POWER SUPPLY
230 V~ +15 – 10% 50 Hz
DIMENSIONS
120 x 74 x 51 mm
CONTAINER
Self-extinguishing ABS IP40 V0
TM
Thermostat
EN
6098090 - IT - EN - DE - FR
Publicidad
Tabla de contenido
