Publicidad
Idiomas disponibles
Idiomas disponibles
Parts in contact with medium
`
`
Stainless steel 1.4404/AISI 316 L
`
`
Stainless steel 1.4310/ AISI 302
Scope of delivery
1 x
Adapter for lance
1 x
Spiral screw
1 x
Lance
100 x Sampling bag, 400 ml
1 x
Bag clip
1 x
Bosch drive unit
2 x
Rechargeable battery
1 x
Battery charger
1 x
Zange für Sicherungsring
1 x
Cleaning brush
`
`
Check delivery for completeness and transport damage.
`
`
Point out any damage in the packaging to the
freight forwarder/supplier immediately.
Assembly
1. Insert the adapter for the lancing device into the
drive unit holder of the Bosch drive unit . Turn
the locking ring in the direction
it snap into place.
NOTE!
Follow the safety instructions for the Bosch drive unit.
2. Insert spiral screw into lance .
CAUTION!
Bodiliy injury due to squeezing the fingers.
`
`
Insert the spiral screw carefully.
3. Screw the lance to the adapter for lance using
the union nut . (Pay attention to the positioning
of the coupling sleeve to the spiral holder .(see
pictures below))
until you hear
4. Insert sampling bag into the bag clip
5. Attach bag clip
Safe sampling
CAUTION!
Possibility of electrical shock.
`
`
Follow the instructions of the drive manufactu-
rer/battery charger manufacturer.
10
CAUTION!
Pointed parts on the instrument. Risk of injury.
11
`
`
Do not pierce the instrument completely
through the container.
`
`
Keep persons and body parts out of the danger area.
CAUTION!
15
Entanglement of the sampler by moving parts in
the silo.
`
`
Do not use the instrument, if moving parts in
the silo are operating.
1. Set the gear selector switch
speed range) and press the On/Off switch
WARNING!
Bodily injury due to entanglement of hairs or fingers.
`
`
Keep fingers and hairs away from tip of lance.
NOTE!
When sampling from a closed bag, do not switch on
the drive until the bag wall has been pierced with the
tip of the lance.
2. Insert the lance into the sample material.
CAUTION!
Possible danger of breakage during operation.
`
`
Do not perform any lever movements.
3. To end sampling, release the On/Off button
4. Pull the instrument out of the sample material.
After taking the sample
1. Remove the bag clip
2. Remove the sampling bag from bag clip
seal it.
3. Unscrew the lance from adapter for lance using
the union nut .
to sample outlet
.
1 1
1 2
to „Gear 1" (low
13
from the sample outlet
1 1
English
.
11
.
1 4
.
1 4
.
1 2
and
1 1
Publicidad
