2.Assemble the filter unit into tank
Align the rib and slot, put the filter
Unit into the tank, align the filter
Unit plane to the step of the tank.
ATTENTION:
If the filter unit is not in the right position, there is risk of leakage.
Don't use the cleaner without the filter in tank.
Use your finger to hold the rib of the filter, and drag the whole unit out. Then hole the unit to turn the
filter left direction to take out the filter from the support. Don't take the filter from the tank directly
while it is difficult to take out the filter support from the tank without the filter.
3. Assemble The Turning Connector With Tank
Align the screw ring to the tank, then tighten the ring to the right clock direction.
4.Assemble The Tank Unit With The Main Body
Align the rib and notch, turn the tank to the body,
then hear a "ka", the tank locked by the latch hook.
Push down the turning connector,
then you can turn the connector free to adjust the suction direction
To Remove The Tank From The Main Unit: Push the button to the front position, then press the button
down, and take out the tank.
5.Assemble The Accessories
You can change the accessories easily. Choose one accessory to insert into the connector directly.
Just pull out and change another.
The scraper is used for window and plane surface, it is just used for liquid .
The soft crevice tool is used for corner situation, it is used for liquid and dust .
The small brush is use for sofa, bed, floor, curtain, etc, it is only used for dust.
6.Charge The Appliance
Plug the charge on wall electrical outlet, insert the charge plug into the proper socket, the indicator is
on red. When the light turns into green, it is full charged, pull out the charger.
7.Assemble The Spray Unit
Assemble the spray head with the water bottle by screw cover.
Align the slot of the spray head and mop support, push the support along the slot, when the clips is locked,
the support is fixed.
Insert the mop support end into the elastic tap, fasten the other end by the nylon tap.
15