Brunton ALL DAY 2.0 Guia De Inicio Rapido página 2

POWER FORWARD
The ALL DAY 2.0 extends the power of your HERO™, HERO™3+ and HERO™ 4 models to
more than 5X the specified run-time of the standard battery alone supplied with
your GOPRO® while still offering the rugged, waterproof* performance your camera
requires.
1. Remove existing GOPRO® case back and travel cover from ALL DAY 2.0 By opening
door and pulling straight down out of brackets. Do not remove pin from door.
2. Snap on ALL DAY 2.0.
3. Attach flat USB cable plug to camera's USB input port using specified mini-USB
outlet depending on camera type (see back diagram below). Attach
opposite end of flat cable to camera's mini-USB power input port and close case.
Ensure cable is not caught in door when closed.
4. Open side door, press ALL DAY 2.0 power button. Shoot longer .
* This product is waterproof up to 40M. Test battery/case for leaks BEFORE placing GOPRO®
in the case before EVERY use and ensure side access door latch is fully engaged. Brunton
is NOT responsible for camera damage while using Brunton products.
POWER UP
Open ALL DAY 2.0 side access door and press power button to supply power to camera.
Charging indicator LED on camera will light to the status of the battery, red or green.
Press again to power off All Day 2.0.
The ALL DAY 2.0 can charge your smartphone or other USB charged device while
powering your GOPRO® camera at the same time. It can also be used as a convenient,
portable, stand-alone power source so you never have to power down. When used as a
portable power bank, please make sure travel cover is snapped onto the ALL DAY 2.0.
To use, open Patented side access door and plug USB powered device into USB output
port.
When closing side door, ensure latch is engaged to create waterproof seal.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To recharge the ALL DAY 2.0, connect micro-USB input cable to a running computer,
USB outlet, or a Brunton portable power device. A solid red light on the battery level
LED indicator indicates that the ALL DAY 2.0 is charging.
BR-Manual-ALLDAY 2.0_5.indd 2
1. 2. 3.
1. USB Output
(Charge other devices)
2. Power Button
3. Micro-USB Input
(Charge ALL DAY 2.0)
2
4.
9/8/15 11:40 AM