Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL ROLLER
With red levers in closed
position, slide roller onto
support bars.
ALIGN SUPPORT BARS
Open both red levers. Slide
roller and support bars back
and forth to check for smooth
operation. This action will
help to align support bars.
Once aligned, tighten the front clamps completely, using firm pressure. Be sure to align
front knobs' markings with markings on clamps. No interference between knobs and
support bars should occur. Then tighten rear clamps with firm pressure.
Instruction #1034172C-7/57
Note: roller to be angled upward.
Use the provided wrench to
tighten the bolts on each side.
Be sure that support bar is fully
inserted into t-lug before tightening.
Publicidad
