Panasonic TY-ST65P20 Instrucciones De Instalación página 12

Assembly Procedure
4. Plasma Display Overturn-Prevention
Anchor the plasma display to both the base and the wall surface.
Anchoring to the base
Attach the overturn-prevention belts
using screws
screws) to anchor to the base.
When attaching to the base, insert the wood screws into the prepared holes.
If there are no prepared holes, drill new holes to the center of the base board width.
(Screw
Overturn-prevention
clamp
Front face
Anchoring to the wall
Pass sturdy string, wire, or other item
through the hooks attached in Step 2.
and anchor the string etc. to a secure wall
or pillar.
* Use a commercially available string,
wire or other item.
For safety reasons, overturn/fall prevention measure must be always taken
The unit may overturn in the event of an earthquake etc. Therefore, overturn/fall prevention measure must be
always taken.
* The details in this section indicate how to reduce any damage or injury caused by this unit overturning or
falling due to an earthquake or other reason. However, there is no guarantee that the overturn/fall prevention
accessories will be effective in all earthquake or other situations.
12
(2 screws) and overturn-prevention clamps
tightening torque: 1.2 to 1.5 N•m)
Overturn-prevention belt
Screw
Wood screw
(2 belts) to the screw holes at both sides of the rear of the pedestal
(2 clamps), and use the wood screws
Screw
Locate the wood
screw at the center of
the material width.
Overturn-prevention
clamp
Overturn-prevention belt
Wood screw
フック Hook
(2