Timer mode settings
1
When Timer mode is selected, Time to ON is
requested to set a delay for ON if desired.
Select 00:00 if no delay is desired.
2
Fan mode is requested and can be cycled
using
or
confirm.
Fan modes:
‒ High Cool
‒ Low Cool
‒ High Vent
‒ Low Vent
3
Running Time is requested to set an operation
length and can be increased or decreased
using
or
then Select button to confirm.
NOTE: Pre-wet status will vary with Configuration
settings. If ON, Pump Only will start for 2 minutes
before it goes to selected Fan mode.
NOTE: Pump only is not available for direct
selection and it depends on Pre-wet status.
NOTE: Clock is replaced by a temporizer during
Timer Operation.
4
After Timer mode settings are completed, Fan
button can be used to change Fan mode from
Home screen.
After Timer mode settings are completed, Time
5
to ON, Fan mode and Running Time can be modified
using
or
Schedule mode settings
1 When Schedule mode is selected, the
configuration settings for programming
are used and go to Home screen without
requesting additional settings.
2 When Pre-wet is ON, Pump Only mode will
start 2 minutes earlier than ON time (i.e.
7:00).
3 While Schedule mode is running, Fan button
can be used to change Fan mode from Home
screen.
NOTE: Pre-wet status will vary with
Configuration settings. If ON, Pump Only will
start for 2 minutes before it goes to selected
Fan mode.
NOTE: Pump only is not available for direct
selection and it depends on Pre-wet status.
buttons, then Select button to
buttons in 15 minute intervals,
buttons from Home screen.
3
Time to ON
M on
Pre-Wet
On
Timer
Mode
Back
Select
MCR37425
Time to ON
M on
Pre-Wet
On
Hi Cool
Timer
Mode
Back
Select
MCR37426
Running Time
M on
Pre-Wet
On
Hi Cool
Timer
Mode
Back
Select
MCR37427
Running Time
M on
Pre-Wet
On
Hi Cool
Timer
Mode
Menu
Fan
M37428
Running Time
M on
Pre-Wet
On
Hi Cool
Schedule
Mode
Back
Select
MCR37429
PM
M on
Pre-Wet
On
Pump Only
Schedule
Mode
Menu
Fan
M37430
PM
M on
Pre-Wet
On
Hi Cool
Schedule
Mode
Menu
Fan
M37431