Installing The Batteries - Paw Patrol PW-119 Manual Del Usuario

Installing the Batteries

ATTENTION:
Batteries should only be installed by an adult.
The unit comes with batteries already installed. These batteries are
meant for in-store demonstration use only, and should be replaced
with fresh batteries. To replace the batteries at home:
1
Use a Philips screwdriver to open the battery compartment
door.
2
Install 3 "AAA" size batteries into the compartment,
making sure that the + and - polarities match the diagram
printed inside.
3
Close the battery
compartment door and
tighten the battery door
screw. Don't over tighten.
Battery Use Cautions and Tips
for Safety and Best
Performance
• Only use the recommended/
supplied batteries or equivalent
• Use alkaline batteries for longer life
• Do not mix old and new batteries, and do not mix alkaline,
carbon-zinc or rechargeable nickel-cadmium batteries
• Insert batteries with proper polarity (+/–) as indicated
• Remove exhausted batteries from product
• Recharge rechargeable batteries under adult supervision
• Do not attempt to recharge non-rechargeable batteries
• Do not open batteries or heat them beyond normal ambient
temperatures.
• To prevent battery leakage or damage remove batteries from a
product if it will not be used for a month or longer.
• Use extreme caution handling leaking batteries (avoid direct
contact with eyes and skin). If battery leakage comes in
contact with eyes, IMMEDIATELY flush the eye with lukewarm
and gently flowing water for at least 30 minutes. If skin contact
occurs, wash skin with clear water for at least 15 minutes.
Seek medical attention if any symptoms occur.
• Store in cool, dry, ventilated area away from hazardous or
combustible material.
• Do not dispose of batteries in the household trash or fire
• Follow applicable laws and local regulations for the disposal
and transportation of batteries.
Maintenance
It is important to keep the unit as dry and clean as possible. Clean
the unit with a soft cloth moistened only with mild soap and water.
Stronger cleaning agents, such as thinner or similar materials are
not recommended, as they may damage the surface of the case.
Do not allow dirt, sand, small particles, water or other liquids to
enter the toy's casing.
If the unit is to be left unused for an extended time period, such as
a month or longer, have an adult remove the battery to extend its
life and to prevent leaking or corrosion.
Battery Installa tion
2
Remove Demo Tab
• The unit is equipped with a Try Me feature. Before using the unit,
pull out the plastic Demo Tab located on back panel.
Using Your Voice Change Communicator
Using the Microphone
Press the microphone button while speaking into the top of
the microphone. Release button to mute the microphone.
TIP: To avoid feedback (unpleasant squealing or howling
sound), do not point the mic towards the speaker.
Sound Effects Buttons
Press and release the four different Sound Effects Buttons
on the front of the unit to cycle through a variety of cool sound
effects!
Volume Switch
Adjust the volume to 'high' or 'low' using the Volume Switch
located on the side of the unit.
Voice Effect Rotary Dial
While speaking through the microphone, move the rotary dial
up or down to warp your voice from low and deep to high
and squeaky!
Strap
Use the velcro strap to attach the unit to your arm or wrist
and take it anywhere! Note: Do not overtighten.
Aux-in Jack
Plug one end of a 3.5mm audio cable (not included) into the
line-in jack, and the other end into the headphone jack of
your MP3 player or other audio device to play your music
through the speaker!
Questions or Comments
For questions or comments regarding this or other
eKids products, please call our toll-free number :
1-888-TOP-TOYS.
Please also visit our website: www.ekids.com
© 2018 eKids, LLC
Questions? Visit www.ekids.com
or call 1-888-TOP-TOYS
1299 Main Street Rahway NJ 07065
Printed in China
EN
PW-119 180226-A(UN-EN)