Publicidad
Idiomas disponibles
Idiomas disponibles
Rubber isolator
Loosen these bolts on
exhaust so that mufflers can
be rotated downward, after
removing muffler hanger
tangs out of rubber isolators
typical both sides of vehicle
shown above.
Slide hitch bracket up in
place between outside of
frame and inside of this
bolt, typical both sides.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2010, 2011, 2015 Cequent Performance Products – Printed in Mexico
Installation Instructions
All models including V-6, V-6 Premium, GT 5.0 Liter, GT- Premium,
GT/California-Special & Shelby GT500 5.4 Liter
And convertible models of the above.
Picture 3.
Tighten 7/16"-14 x 1-1/2" Carriage Bolts with torque wrench to 50 Lb.-Ft. (68 N*M)
Ford Mustang
Sheet 2 of 6
60280
77238
24843
Picture 1.
Access hole
Muffler hanger tang
Picture 2.
Outside of Passenger's side
frame rail shown with ends of
Bolt Leaders sticking out.
Be careful not to push ends
back in to frame when raising
hitch up in to place.
24863N
10-07-15
Part Numbers:
24863
(U-Haul)
Rev. D
Publicidad
