Publicidad
Idiomas disponibles
Idiomas disponibles
3-12 Ocean Battery Voltage setting suggestion
GEL TYPE (Max. Voltage of 14.1 / 28.2 Volt)
AGM TYPE (Max. Voltage of 14.4 / 28.8 Volt)
Lead-Acid (Max. Voltage of 14.8 / 29.6 Volt)
4. Installing the Ocean Battery Charger
(See the electrical connection at the end of the manual).
When selecting the installation location, observe the following instructions:
The battery charger can be installed horizontally or vertically.
Do not install the charger in following situations:
In wet environment
In dusty environment
In the vicinity of combustible materials
In areas where there is a danger of explosions
The place of installation must be well ventilated. A ventilation system must be available for installation
in small, enclosed space. The clearance around the device must be at least 25cm.
The charger must be installed on a level and sufficiently sturdy surface.
Do not install the charger above batteries, because they can emit corrosive sulphur fumes that will
damage the device.
For ambient temperatures higher than 40 ℃ (such as in engine or heating compartments, or direct
sunlight), the heat from the charger under load can lead to reduced output.
The air inlet on the underside and the air outlet on the back of charger must remain clear.
5. Trouble Shooting
LED display
Red, slowly flashing
Red, permanently lit
Red, double flash
Red, slow double flash
6. Warranty Statement
We guarantee this product against defects in materials and workmanship for a period of 24 months from the date of
purchase. Please contact your local MZ authorized distributor for RMA (Return material Authorization) service. Please
note that MZ is only responsible for ensuring our products are operational before delivery. This warranty will be
considered void if the unit has been misused, altered, or accidentally damaged. MZ is not liable for anything that
occurs as a result of the user's fault.
Cause
Battery under voltage or
battery overload
Defective battery
Overheating
Short circuit or reversed
polarity
Fan fault
Fault at the starter battery
connection
Check the battery.
Switch the battery charger off and on again.
Replace the battery
Improve the ventilation of the battery charger or battery.
Make sure that no ventilation openings are covered.
If necessary, reduce the ambient temperature.
Connect the battery charger with the correct polarity.
Rectify the short circuit.
Check if the fuse has blown and replace it if necessary.
Check the fan for dirt or damage.
Check the starter battery connection for a short circuit.
- 8 -
English
Remedy
Rev. 06/2016
Publicidad
