Safety And General Information; Product Description - Omega Lift Equipment MagicLift 32066 Instrucciones De Operación Y Manual De Piezas

SAFETY AND GENERAL INFORMATION

Save these instructions. For your safety read, understand, and follow the information provided with and on this
pair of jack stands before using. The owner and operator of this equipment shall have an understanding of the jack
stands and safe operating procedures before attempting to use. The owner and operator shall be aware that use of
this product may require special skills and knowledge. Instructions and safety information shall be conveyed in the
operator's native language before use of these jack stands is authorized. If any doubt exists as to the safe and proper
use of these jack stands, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked, or damaged parts (including labels) are noted. Any
jack stand that appears damaged in any way, operates abnormally or is missing parts, shall be removed from service
immediately. If you suspect that the jack stand was subjected to a shock load (a load dropped suddenly, unexpectedly
upon it), immediately discontinue use until the stand has been checked by a factory authorized service center (contact
distributor or manufacturer for list of Authorized Service Centers). It is recommended that an annual inspection be
done by qualified personnel. Labels and owner's manuals are available from manufacturer.

PRODUCT DESCRIPTION

Omega "MagicLift™" Jack Stands are designed to support rated capacity, partial vehicle loads consisting of one end
of a vehicle. Your Omega Jack Stands have a special Magic-Lift feature which allows the ratchet bar to automatically
adjust till it makes contact. Use as a matched pair to support one end of a vehicle only.
WARNING: Never use automotive jack stands to support both ends or one side of a vehicle! Use only one (1)
!
pair per vehicle. Rated capacity is per pair only!
! WARNING: The "Magic Lift" adjustment function of this jack stand is not designed to support a load. The
Locking Pawl must be properly engaged for the jack stand to support weight.
SPECIFICATIONS
Model Capacity (per pair)
32066
32126
Locking Handle
Base Size
6 Ton 11" x 9-3/4"
12 Ton 14-3/4" x 12-3/4"
Ratchet Bar Collar
Figure 1 - Models 32066 & 32126 Components (model 32126 shown)
Min. Height
15-3/4"
19-3/4"
Ratchet Bar
Spring
Ratchet Bar
Locking Pin
Locking Pawl
Air Spring
Base Frame
2
Max. Height
24-3/8"
30-1/4"