Technical Data; Assembly & Operation - Walmart HYPER YOUGH HT19-401-003-18 Manual Del Operador

Rated Voltage
Rated Power
Rated No-load speed
Protection class
Blade diameter
Blade cutting depth
Machine weight
We recommend that you purchase your accessories from the same store that sold you the tool.
Refer to the accessory packaging for further details. Store personnel can assist you and offer
advice.
Assembly
Assembling the Shaft
Assembling the Auxiliary Handle
Attaching the Extension Cord
Operation
Setting to the edging position
Edging
Adjusting Cut Depth
Setting to the trenching/landscaping position
Trenching and landscaping operation
Removing and attaching the blade
OPERATION INSTRUCTION
NOTE:
The edger is a major appliance and should not be operated simultaneously with other major appliances on the same
household circuit.
Warning: Make sure that other persons and pets are at least 100 feet away.
EDGING
1. Before starting the edger, line up the tool so the edge guide rests against the edge of the paved surface. Both rear wheels
should be on the paved surface when edging. (See Fig D2)
2. To avoid kickback of edger, tilt the handle down so the blade is above the ground (See Fig D3).
3. Turn switch ON and allow blade to spin without moving tool.
4. Slowly lift the handle to lower the blade, finding the edge of the paved surface and start edging. Then move tool
forward slowly along edge of paved surface, keeping the edge guide pressed lightly against the pavement edge. For
the first edging each season, it is best to move forward slowly because grass is thickest then. Subsequent edging will

TECHNICAL DATA

ASSEMBLY & OPERATION
ACTION
8
120V~60Hz
12A
4700/min
/ll
7-1/2"
1", 1-1/4", 1-1/2"
14.2lbs
FIGURE
See Fig. A
See Fig. B
See Fig. C1&C2
See Fig. D1
See Fig. D2&D3
See Fig. E1&E2
See Fig. F
See Fig. G1&G2